Broken views
Broken views
(OP)
Hi all,
I have a detail of a shaft 2m long. In draughting I have 2 views of the shaft each view has a break in it. Is there an easy way of aligning the views and making both views the same length?
Andy.
I have a detail of a shaft 2m long. In draughting I have 2 views of the shaft each view has a break in it. Is there an easy way of aligning the views and making both views the same length?
Andy.





RE: Broken views
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3