Can i place section view of a Broken view
Can i place section view of a Broken view
(OP)
Hi All,
I am using NX6.0.2.8. I have a broken view in my drawing sheet. But i am not able to create a section view from that broken view. Any suggestions?
I am using NX6.0.2.8. I have a broken view in my drawing sheet. But i am not able to create a section view from that broken view. Any suggestions?





RE: Can i place section view of a Broken view
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.