NX6 changing from threaded hole to general hole
NX6 changing from threaded hole to general hole
(OP)
Is there a method of changing from threaded holes to general holes after having created threaded holes? i have a pattern of threaded holes that I would now like to change to clearance holes without having to redefine the hole locations.





RE: NX6 changing from threaded hole to general hole
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 changing from threaded hole to general hole
RE: NX6 changing from threaded hole to general hole
RE: NX6 changing from threaded hole to general hole
RE: NX6 changing from threaded hole to general hole