Automatic mass in drafting table
Automatic mass in drafting table
(OP)
Hi
My question is how to add automatically part mass to the drafting table.
I suitabled material to the part nad changed units to "g-mm".
In mass field added property : <W@?MASS> .... and see nothing.
Please help :)
My question is how to add automatically part mass to the drafting table.
I suitabled material to the part nad changed units to "g-mm".
In mass field added property : <W@?MASS> .... and see nothing.
Please help :)





RE: Automatic mass in drafting table
Or if this is not what you are looking for, try the search function on this forum and search for mass attribute, you get a lot of hits.
Succes.
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
RE: Automatic mass in drafting table
URL:http://www.eng-tips.com/viewthread.cfm?qid=253382
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3