NX 7.5 Flat Pattern Annotation
NX 7.5 Flat Pattern Annotation
(OP)
Is there a way to control the annotation in Flat pattern in NX Sheet Metal? Specifically, to change the "Bend Angle" and "Bend Radius" tolerance from n.nn to n?
Thanks
Munners
Thanks
Munners





RE: NX 7.5 Flat Pattern Annotation
The content will have !KEY=0,3.2 where the 3 is before the decimal point and 2 is after the decimal point. So to change to 0 make it 3.0
For example:
Bend Radius = <!KEY=0,3.0@UGS.radius>
It's funny, I spoke to a customer about this exact question just today didn't I munners
Anthony Galante

Technical Resource Coordinator
NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.4.4, Beta NX8.0.0.25