Stadard english/metric tolerence fits in NX
Stadard english/metric tolerence fits in NX
(OP)
Is there a way to set the hole and shaft tolerance fits that are standard in the english and metric systems?
Example: RC1, H8, g6 etc.
Example: RC1, H8, g6 etc.
NX6.0.5.3 mp07, Windows XP 64-bit,Team Center 8.1
Running cad straight out of the box is OK but, a system tuned with application software is the best way to increase productivity.





RE: Stadard english/metric tolerence fits in NX
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Stadard english/metric tolerence fits in NX
NX6.0.5.3 mp07, Windows XP 64-bit,Team Center 8.1
Running cad straight out of the box is OK but, a system tuned with application software is the best way to increase productivity.