Probing down deep bore on turn/mill using NX6
Probing down deep bore on turn/mill using NX6
(OP)
Hi
I am trying to probe internal diameter down the inside of a deep bore on a 6 meter bed turn/mill using NX6.
I have only been an NX programmer for around a year so could do with a few pointers.
Many thanks in advance
Ian
I am trying to probe internal diameter down the inside of a deep bore on a 6 meter bed turn/mill using NX6.
I have only been an NX programmer for around a year so could do with a few pointers.
Many thanks in advance
Ian




