Yes - Save and close => NO-CLOSE please
Yes - Save and close => NO-CLOSE please
(OP)
Once you are familiar with the use of the middle mouse button it's a real enhancement in NX.
But habits are difficult to change.
After 4y using NX4 now made the switch to NX7.5. And guess what, File-Close-All Parts is now Yes-Save and close preselected instead of No-Close. Many many many many many times i clicked the middle mouse button.
Is there a way to change the preselection of the buttons.
I like to have No-Close preselected.
Thanks.
But habits are difficult to change.
After 4y using NX4 now made the switch to NX7.5. And guess what, File-Close-All Parts is now Yes-Save and close preselected instead of No-Close. Many many many many many times i clicked the middle mouse button.
Is there a way to change the preselection of the buttons.
I like to have No-Close preselected.
Thanks.
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3





RE: Yes - Save and close => NO-CLOSE please
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.