Invalid or Unsuitable OM Object
Invalid or Unsuitable OM Object
(OP)
I'm hoping that someone can help me figure out how to get around this error and has seen this before. We just upgraded to NX 6.0.5.3 MP4 and started seeing the error below just after the upgrade when opening only some files.
Could not open XXXXXX
The following files could not be loaded causing this open to fail:
XXXXX - An operation was attempted on an invalid or unsuitable OM object
Thanks for your help.
Could not open XXXXXX
The following files could not be loaded causing this open to fail:
XXXXX - An operation was attempted on an invalid or unsuitable OM object
Thanks for your help.





RE: Invalid or Unsuitable OM Object
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: Invalid or Unsuitable OM Object
RE: Invalid or Unsuitable OM Object
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.