Follow-up to a now closed thread...
Follow-up to a now closed thread...
(OP)
There was a question asked and answered in a thread which has since been closed:
http://www.eng-tips.com/viewthread.cfm?qid=292178
Well, IT'S SEPTEMBER...
http://www.eng-tips.com/viewthread.cfm?qid=292178
Well, IT'S SEPTEMBER...
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.





RE: Follow-up to a now closed thread...
BTW it also runs on Mac OS Lion.
2x NX 7.5.4.4 mp2 and NX8.0.0.25 Mach Design
1x Solid Edge ST2
RE: Follow-up to a now closed thread...
win7 64bit
Thanks.
RE: Follow-up to a now closed thread...
I have a beta license file, probably that makes it working for me.
Greetings,
Frank
2x NX 7.5.4.4 mp2 and NX8.0.0.25 Mach Design
1x Solid Edge ST2
RE: Follow-up to a now closed thread...
As to the issue of not getting a response today, that was probably due to the fact that in the US and Canada, it was a national holiday (Labor Day).
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Follow-up to a now closed thread...
Anthony Galante

Senior Support Engineer
NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.4.4, Beta NX8.0.0.23
RE: Follow-up to a now closed thread...
Thanks
Joey
RE: Follow-up to a now closed thread...
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.