Joining two sheetmetal bodies using a mitre flange?
Joining two sheetmetal bodies using a mitre flange?
(OP)
I have two sheetmetat bodies and I would like to join them using a mitre flange. I have defined the mitere flange using a sketch.
At the moment I can only get the mitre flange to attach to one of the bodies.
Thanks in advance, Chris.
At the moment I can only get the mitre flange to attach to one of the bodies.
Thanks in advance, Chris.






RE: Joining two sheetmetal bodies using a mitre flange?
ht
Why not start with the fully formed extrude?
RE: Joining two sheetmetal bodies using a mitre flange?
Its rework of a design and I didnt want to re make relations etc.
RE: Joining two sheetmetal bodies using a mitre flange?