Back to SW, trying to create angular dim in part
Back to SW, trying to create angular dim in part
(OP)
Hello, I am back to SW after 5 years, switching from SE ST3. Since it has been long, I need to get myself oriented to UI.
my first Q
in part, I'm trying to create anglular sketch dim. By clicking only innclined line, linear dim starts by default, how can I convert to angular?
Thanks
Bhavesh
my first Q
in part, I'm trying to create anglular sketch dim. By clicking only innclined line, linear dim starts by default, how can I convert to angular?
Thanks
Bhavesh






RE: Back to SW, trying to create angular dim in part
Line and point
Two non-parallel lines
3 points
htt
RE: Back to SW, trying to create angular dim in part
If guns kill people, cars drive drunk.