What's wrong with my SolidWorks 2010? Always overlapping
What's wrong with my SolidWorks 2010? Always overlapping
(OP)
I just installed Solidworks 2010(64bit) on my laptop, but when I use 2d or 3d it always has overlapping when i roll the mouse middle button, see the attached photo.
don't know why. My laptop is Toshiba Satellite L350D, AMD Turion 64X2 Dual-Core 2GHz, 4GB 800Mhz SDRAM, 250GB HDD with Vista 64 bit system.
Graphics processor: ATI Radeon X1250
Is my laptop too slow for the SolidWorks 2010? Or the Vista doesn't support SW2010 very well?
Thanks!
don't know why. My laptop is Toshiba Satellite L350D, AMD Turion 64X2 Dual-Core 2GHz, 4GB 800Mhz SDRAM, 250GB HDD with Vista 64 bit system.
Graphics processor: ATI Radeon X1250
Is my laptop too slow for the SolidWorks 2010? Or the Vista doesn't support SW2010 very well?
Thanks!






RE: What's wrong with my SolidWorks 2010? Always overlapping
The Radeon series is not suitable for SW. See the following link for approved cards.
http://w
However, some people have been reporting that RealHack 1.5 from http:/
RE: What's wrong with my SolidWorks 2010? Always overlapping
htt
http:
RE: What's wrong with my SolidWorks 2010? Always overlapping
RE: What's wrong with my SolidWorks 2010? Always overlapping