Associative Dimension measurement
Associative Dimension measurement
(OP)
Hello,
I have a surface which I added draft. Now I created an associative dimension measurement which measures the minimum distance. But whenever I change the draft, the distance measurement gets an error "Erro recovery completed for the following error: There is an object which depends on itself"
I'm not sure but I think this used to work on nx5 or nx3.
I have a surface which I added draft. Now I created an associative dimension measurement which measures the minimum distance. But whenever I change the draft, the distance measurement gets an error "Erro recovery completed for the following error: There is an object which depends on itself"
I'm not sure but I think this used to work on nx5 or nx3.
UGNX7.5.2.5 MP3 Rev D \ Windows 7 64bit
Productive Design Services
www.productivedesign.com





RE: Associative Dimension measurement
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.com/museum/
To an Engineer, the glass is twice as big as it needs to be.