Trimmed Sheet curve suggestions
Trimmed Sheet curve suggestions
(OP)
Hello,
When using the command "Trimmed Sheet" UG always makes suggestions on the "boundary objects". Is there a way to turn this off?
Sometimes it gets confusing if I already selected an edge or not.
When using the command "Trimmed Sheet" UG always makes suggestions on the "boundary objects". Is there a way to turn this off?
Sometimes it gets confusing if I already selected an edge or not.
UGNX7.5.2.5 MP3 Rev D \ Windows 7 64bit
Productive Design Services
www.productivedesign.com





RE: Trimmed Sheet curve suggestions
Preferences -> Selection...
...and in the section of the dialog titled 'QuickPick' toggle OFF the 'QuickPick on Delay' option. Now 'QuickPick' will no longer be activated automatically but ONLY after you've held MB1 down for a half-second or longer.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.com/museum/
To an Engineer, the glass is twice as big as it needs to be.