NX6 Journal: You can't automate a section view?
NX6 Journal: You can't automate a section view?
(OP)
Hello everyone -
It is my understanding that you cannot journal a section view in NX6. Is this true?
My company always creates a "right view" as a base view and always sections this view to create their draft, I was hoping to create a journal to automate this task, but cannot find a way to do this. Is it possible?
Thanks in advance
It is my understanding that you cannot journal a section view in NX6. Is this true?
My company always creates a "right view" as a base view and always sections this view to create their draft, I was hoping to create a journal to automate this task, but cannot find a way to do this. Is it possible?
Thanks in advance





RE: NX6 Journal: You can't automate a section view?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.com/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX6 Journal: You can't automate a section view?
Does this mean that even in NX8 that this will not be added?
sumBuddy (Mechanical)
--------------------------------------------------------------------------------
"I would like to change the world, but I can't find the source code."
RE: NX6 Journal: You can't automate a section view?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.com/museum/
To an Engineer, the glass is twice as big as it needs to be.