NX manufacturing: how to setup tool change time
NX manufacturing: how to setup tool change time
(OP)
Hello,
I am new to this forum, so hello to everybody.
Please let me know how to change the default tool changeover time in nx manufacturing, so the time calculations of my operations will be accurate. I am using NX7.5
Thank you.
I am new to this forum, so hello to everybody.
Please let me know how to change the default tool changeover time in nx manufacturing, so the time calculations of my operations will be accurate. I am using NX7.5
Thank you.





RE: NX manufacturing: how to setup tool change time
Where are you looking at the time?
The value on the operation navigator cannot be changed as far as I know.
In post builder on the tool change event you can set the time.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3
RE: NX manufacturing: how to setup tool change time
See also attached picture.
Kind regards, Bert Claessen
RE: NX manufacturing: how to setup tool change time
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3
RE: NX manufacturing: how to setup tool change time
Mark Rief
Product Manager
Siemens PLM