modeling of beam to wall interface in abaqus
modeling of beam to wall interface in abaqus
(OP)
hi all,
I modeled a steel coupling beam into concrete shear wall,
i am going to verify an exprimental model,but i steel couldn't get it, i think my problem is in modeling of beam to wall interface, i used embedded constraint, but it hasn't correct result,
please help me.
thank you
I modeled a steel coupling beam into concrete shear wall,
i am going to verify an exprimental model,but i steel couldn't get it, i think my problem is in modeling of beam to wall interface, i used embedded constraint, but it hasn't correct result,
please help me.
thank you





RE: modeling of beam to wall interface in abaqus
Rob Stupplebeen
https://sites.google.com/site/robertkstupplebeen/
RE: modeling of beam to wall interface in abaqus
I was going to use coupling constraint between one point in beam and one point from wall,but when i used coupling constraint and run,the job aborted and was not converge,
i sent my inp file.
thank you
RE: modeling of beam to wall interface in abaqus
Rob Stupplebeen
https://sites.google.com/site/robertkstupplebeen/