sweep profile starting in the middle of a path
sweep profile starting in the middle of a path
(OP)
So I realize that a sweep is not bidirectional and must start at the end of a path in order to run the entire path.
However, I want the sweep to only run part of the path, however solidworks automatically chooses to run in the wrong direction, is there any way to change the direction the sweep chooses to run?
However, I want the sweep to only run part of the path, however solidworks automatically chooses to run in the wrong direction, is there any way to change the direction the sweep chooses to run?






RE: sweep profile starting in the middle of a path
Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog
RE: sweep profile starting in the middle of a path
ht