Load options
Load options
(OP)
Hi,
Can I ask what the difference between latest working and alpha REV order is?
I'm loading an assembly which has a revision A and B of a part. When I load using latest working it loads REV A, when I load using alpha REV order I get REV B.
I can't quite understand what it's doing, any help appreciated.
Can I ask what the difference between latest working and alpha REV order is?
I'm loading an assembly which has a revision A and B of a part. When I load using latest working it loads REV A, when I load using alpha REV order I get REV B.
I can't quite understand what it's doing, any help appreciated.





RE: Load options
RE: Load options
RE: Load options
The part in question is in a few assemblies, I can load one of them and it will load a different revision to the other. Surely this shouldn't be possible?
RE: Load options
Do you have the 'load as saved' option checked or not?
Are you using out of the box part revision rules or something custom?
RE: Load options
The part revision rules are out of the box.
Any ideas much appreciated. It seems very strange that the revision it loads can differ between assemblies.
RE: Load options
Then in the main menu, Tools - Revision Rule - View/Set current...
Select the rule "Latest working" in the left pane, note the definitions in the right pane. ( You should be able to understand the difference between Latest working / Alpha Rev by reading these.)
"Close" the dialog after reading and you have done no change.