Extracted edges problem
Extracted edges problem
(OP)
Hi all,
When I add a view in drafting extracted edges are turned off. When I went to change the customer default setting they are set as being associative.
I want them to be set at associative but the actual setting doesn't seem to reflect the default setting.
Any ideas much appreciated.
When I add a view in drafting extracted edges are turned off. When I went to change the customer default setting they are set as being associative.
I want them to be set at associative but the actual setting doesn't seem to reflect the default setting.
Any ideas much appreciated.





RE: Extracted edges problem
RE: Extracted edges problem