Configure Mates when creating them?
Configure Mates when creating them?
(OP)
Hello all,
I have an assembly with multiple configurations, is there a way to configure the mates when you create them instead of having to go back after creating them and then RMB on the mate and selecting "configure feature"? Basically, is there a way to specify what configurations the mate will apply to during the creation process?
Thanks,
PD
I have an assembly with multiple configurations, is there a way to configure the mates when you create them instead of having to go back after creating them and then RMB on the mate and selecting "configure feature"? Basically, is there a way to specify what configurations the mate will apply to during the creation process?
Thanks,
PD
www.phoenixdyno.com
Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.






RE: Configure Mates when creating them?
RE: Configure Mates when creating them?
Eric