List of program names from operation navigator
List of program names from operation navigator
(OP)
Is there any way to create an automatic populating list or a table in drafting of program names from operation navigator?.Any ideas/suggestions how to do this?





RE: List of program names from operation navigator
Frank Swinkels
RE: List of program names from operation navigator
Frank Swinkels
RE: List of program names from operation navigator
I want to take out some drawings and photos, on my shop floor.
How can I customize this. I want to take out the workpice "cero point" on a drawing or photo, how can I do this...
Thanks.
RE: List of program names from operation navigator
The journal shows typical formats.
Regards
Frank Swinkels
RE: List of program names from operation navigator
You mean that with an VB journal, I can take out GIF images of workpiece drawings and CAM toolpaths photos?
I want to take out the cero workpice photos,the coordetanest etc,
in a GIF or JPG image...
and some toolpaths photos.
The point os how...
Thanks.
RE: List of program names from operation navigator
Frank Swinkels
RE: List of program names from operation navigator
Sadly, it's way over my head.Would truly appreciate if someone could help me create this vb journal.As I wrote in first post I want to find a way to export program names to drafting table.
Thanks for any help you can give.