Creating a simple shape
Creating a simple shape
(OP)
I cant seem to create a simple shape here. I am trying to create a tapered cone on a radial curve. Which is the best/simplest way to do this you think? I am using Sweep/Swept to do it but gives an undesired flat section in my cone shape. See attached JPEG for sketches created to attempt this. Any suggestions?





RE: Creating a simple shape
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Creating a simple shape
RE: Creating a simple shape
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Creating a simple shape
RE: Creating a simple shape