splines
splines
(OP)
I'm trying to create a spline that follows a radiate surface curve. WHen i open a sketch on a plane, select spline and sketch the spline using several points, i cannot seem to stop or end the spline as it disappears whenever i double-click or press esc. to complete it.
Awaiting your response with great anticipation!
Awaiting your response with great anticipation!






RE: splines
BBJT CSWP
RE: splines
Check you grid settings. Tools, options, Document Properties, uncheck all buttons. If your Snap to points are set to on, and your major grid spacing is 10 inches, your sketch will snap to the points. Then you will not see a 3-inch sketch. Good luck.
Bradley