When we changed from WF3 to WF4, but still on PDMLink 9m050, the parameters when we create a new drawing are not being transferred the way they were with WF3. In WF3, the parameters would load across from the model file, but in WF4, we are asked to enter each parameter value. Has anyone else seen this with WF4?
"Wildfires are dangerous, hard to control, and economically catastrophic."
Red Flag Submitted
Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action.
Reply To This Thread
Posting in the Eng-Tips forums is a member-only feature.
Todayâ€™s product development cycle is fraught with difficulties. Increased demands for complex functionality and reduced product development windows cause engineering teams to borrow practices from the IT industry, swapping outdated serial workflows for a more flexible and collaborative design method known as Agile Product Engineering. Download Now
Version control is neither a new concept or a new software feature. But with the explosion of digital information, thereâ€™s an even greater need for tight control and management of documents and data. Download Now