NX7.7 Unable To Select Point On Components Of An Assembly?
NX7.7 Unable To Select Point On Components Of An Assembly?
(OP)
When in an assembly I would like to add lines and/or arcs, but unable to select points on components. Am I missing something because I used to be able to do this in NX4.





RE: NX7.7 Unable To Select Point On Components Of An Assembly?
RE: NX7.7 Unable To Select Point On Components Of An Assembly?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7.7 Unable To Select Point On Components Of An Assembly?
Anthony Galante

Senior Support Engineer
NX4.0.4MP10, NX5.0.0->5.0.6, NX6.0.0->NX6.0.5, NX7.0.0->NX7.0.1 & NX7.5.0.32-> NX7.5.2.5, Beta NX8.0.0.15
RE: NX7.7 Unable To Select Point On Components Of An Assembly?