NX7.5 Viewing A Components Assembly Constraints?
NX7.5 Viewing A Components Assembly Constraints?
(OP)
I searched and found a similar question from 2007 so I am guessing it was concerning an earlier NX version. It referred to a Dependencies window, but I cannot find that, even if it still relavent.
We are using NX7.5 (Upgraded from NX4) and I am trying to determine how to show the component specific mating constraints within an assembly. I see the constrains listed in the ANT, but known of those seem to be realted to the component in question.
We are using NX7.5 (Upgraded from NX4) and I am trying to determine how to show the component specific mating constraints within an assembly. I see the constrains listed in the ANT, but known of those seem to be realted to the component in question.





RE: NX7.5 Viewing A Components Assembly Constraints?
RE: NX7.5 Viewing A Components Assembly Constraints?
Admittedly, it's not perfect and it is slow going, but that's all we've got for now.
NX 6.0.5.3 (NX 8 Beta)
Windows XP32
RE: NX7.5 Viewing A Components Assembly Constraints?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7.5 Viewing A Components Assembly Constraints?
RE: NX7.5 Viewing A Components Assembly Constraints?
RE: NX7.5 Viewing A Components Assembly Constraints?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7.5 Viewing A Components Assembly Constraints?