FEA with CATIA V5 - mesh creation
FEA with CATIA V5 - mesh creation
(OP)
Hi All,
Does anybody know if an Analysis file can create mesh automatically on a new component added to the linked Producct file?
I tried this, but it did not create mesh for the new components and it ignored the newly added components in the simulation.
I had to create a new Analyis file and start pre-processing all over again.
Any advice/tips is appreciated.
Thank you!
Does anybody know if an Analysis file can create mesh automatically on a new component added to the linked Producct file?
I tried this, but it did not create mesh for the new components and it ignored the newly added components in the simulation.
I had to create a new Analyis file and start pre-processing all over again.
Any advice/tips is appreciated.
Thank you!





RE: FEA with CATIA V5 - mesh creation
At least, that is what I usually do.