Tube feature
Tube feature
(OP)
Hi,
I'm not able to create a tube from a sketch, a bridge curve and an helix curve.
Where I wrong ?
I'm not able to create a tube from a sketch, a bridge curve and an helix curve.
Where I wrong ?
Thank you...
Using NX 7.0.1.7 MP3 and TC8.1





RE: Tube feature
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Tube feature
I'm talking about my case.
In my case the tube must sweep along connected curves that are created by sketch, bridge and helix.
In the next version I don't have problem, but in NX7 yes.
Solutions ?
Thank you...
Using NX 7.0.1.7 MP3 and TC8.1
RE: Tube feature
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Tube feature
trim is the only solution ?
Different setting in the bridge feature can avoid create a trim feature and a new bridge feature ?
Why next NX version can do tube feature without problem ?
Is it changed something in the tube feature ?
Thank you...
Using NX 7.0.1.7 MP3 and TC8.1
RE: Tube feature
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Tube feature
we are in maintenance, but remember that in big company move from a release to the next, it's a big time consuming.
We have 50 designer so we have to update for every client 50 NX and 50 TC en all workstation that have TC as web browser.
We have to update TC server also.
Again, we have 20000 parts that need to be converted with the refile tool.
For parts is little simple, but for assembly we need lot of time.
When we switch from NX3 to NX7 we have spent two months.
So we have decide to switch from NX7 to NX8 when will be released.
Thank you...
Using NX 7.0.1.7 MP3 and TC8.1
RE: Tube feature
The feature tolerance was 0.02540, single segment.
RE: Tube feature
you have right.
Today I deleted the bridge curve and re-created and works fine.
Thank you...
Using NX 7.0.1.7 MP3 and TC8.1