Dimension a slot in sketch mode
Dimension a slot in sketch mode
(OP)
I'd like to dimension the entire length of a slot. When I try and move the dimension line to the arcs I get either a yellow or orange square but I'm not able to attach the dimension. What do the yellow and orange squares mean? How do I dimension the slot the way I want to dimension it?






RE: Dimension a slot in sketch mode
RE: Dimension a slot in sketch mode
RE: Dimension a slot in sketch mode
RE: Dimension a slot in sketch mode
Can you post an image showing the squares?
RE: Dimension a slot in sketch mode
ht
http://www.fcsuper.com/swblog/?p=206
Deepak Gupta
SW 2010 SP4.0 & 2011 SP3.0
Boxer's SolidWorks™ Blog
RE: Dimension a slot in sketch mode
Michael