NX software issue, display will not refresh or display part at all!
NX software issue, display will not refresh or display part at all!
(OP)
I tried to colour a part and NX crashed and the display froze. I stupidly saved it, then when i tried to open it again, it opens but does not display the part at all. If i open a window in the display it just stays there even if i close it. Any ideas?





RE: NX software issue, display will not refresh or display part at all!
RE: NX software issue, display will not refresh or display part at all!
You say the display 'froze'. If that's true, how were you able to save the model?
Have you shutdown your system and restarted 'Vista' yet?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX software issue, display will not refresh or display part at all!