Interior demising wall
Interior demising wall
(OP)
I am looking at a 20'steel stud non-bearing demising wall inside an enclosed building (strip mall) in Phoenix. I have had a few different people tell me the minimum interior wind loading required on this wall. I usually go with 10 psf on interior walls, but I cant find a section in the 2006 ibc or ASCE 7 - 02 on it. Any input would help.
Thanks,
Thanks,






RE: Interior demising wall
RE: Interior demising wall
Interior walls and partitions that exceed 6 feet in height, including their finish materials, shall have adequate strength to resist the loads to which they are sujected but not less than a horizontal load of 5 psf.
RE: Interior demising wall
RE: Interior demising wall
RE: Interior demising wall
BA
RE: Interior demising wall