Control Broken Views
Control Broken Views
(OP)
Im trying to find if there is some way of controlling broken views other than by the "Broken View" command. If i go to properties of a broken view in part navigator and click the Information button there is a "Broken View Regions" section. Is there any way of changing the location of the broken views by changing the Location XC, YC, ZC values?





RE: Control Broken Views
When you say "change the location of the broken views", are you talking about moving individual view sections, such as adding additional separation between two 'sections' of the view, or are you talking about moving the entire set of views as if it were one view?
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Control Broken Views
Actually, i need to rephrase my question.
I would like to automate broken view creation and possitioning based on how many times a part is used in a array in the assembly. If a part occurs three times i need four broken views, if it occurs four times i need five broken views.
Arrays are controlled from spreadsheet so if i could somehow incorporate broken view creation and possitioning in same spreadsheet it would be great.
RE: Control Broken Views
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Control Broken Views
One more question. Does this apply to "Detail view" also?
RE: Control Broken Views
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Control Broken Views