How to run ham medic on I-DEAS 5m3
How to run ham medic on I-DEAS 5m3
(OP)
Hi,
Please could you help me!
Created 3D model, part updates without any yellow or red nodes, but beginging of history shows : Internal error in function ha2id/ha2idge at position 10: Unsupported Ham Type.
Thanks
Please could you help me!
Created 3D model, part updates without any yellow or red nodes, but beginging of history shows : Internal error in function ha2id/ha2idge at position 10: Unsupported Ham Type.
Thanks





RE: How to run ham medic on I-DEAS 5m3
http://www