Selection
Selection
(OP)
Don't know what happened. Maybe changed a setting and didn't realize it.
When I click on the WAVE geometry link button, and want to link a Composite curve, I can only select 1 curve at at time. I have to click a curve and then apply. Click a curve and then apply. I can't pick multiple curves at one time and then apply.
Is there a setting for this?
Thank you.
When I click on the WAVE geometry link button, and want to link a Composite curve, I can only select 1 curve at at time. I have to click a curve and then apply. Click a curve and then apply. I can't pick multiple curves at one time and then apply.
Is there a setting for this?
Thank you.





RE: Selection
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
RE: Selection
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.