Is it just me
Is it just me
(OP)
is it just me or is the table on page 161 of the latest version of ASME Section IX for side bend test for welder's qualification confusing? or not well formatted?
Any explaination especially on the last (w) column with with of the rows overlapping and number too?
Any explaination especially on the last (w) column with with of the rows overlapping and number too?





RE: Is it just me
'w' is the thickness of the bend coupon.
RE: Is it just me
I know it's the thickness of the coupon, I'm talking about the table, the width of the rows in the last column overlap to where you don't know the row to the left that they correspond to.
RE: Is it just me
They don't correspond to the rows on the left. The info under the heading 'w' stands alone.
RE: Is it just me