UGNX-5 - How to Create Animation
UGNX-5 - How to Create Animation
(OP)
Per the question in thread561-271903: Animation - Video
My problem is the same issue trying to make a virutal walk-through of a manufacturing plant rather than an airport.
No, I do not want to move components nor have the assembly lines running. Just a virtual tour by walking through the plant via the UGNX Create Animation. Veiw > Visualization > Create Animation
The GTAC Q1, Q2 and Q3 of 2002 were useless in helping as someone tried to offer the advise. That talks about moving components via animation.
Help.
My problem is the same issue trying to make a virutal walk-through of a manufacturing plant rather than an airport.
No, I do not want to move components nor have the assembly lines running. Just a virtual tour by walking through the plant via the UGNX Create Animation. Veiw > Visualization > Create Animation
The GTAC Q1, Q2 and Q3 of 2002 were useless in helping as someone tried to offer the advise. That talks about moving components via animation.
Help.





RE: UGNX-5 - How to Create Animation
Gateway to NX -> Viewing Files -> Animating Models -> Animation as well as -> Trajectories for Navigation and Animation
Note that the 'Trajectories for Navigation and Animation' are probably going to be of more value for what you're describing than would be simple 'animation' but they are part and parcel to each other.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: UGNX-5 - How to Create Animation
Regards
Felix
RE: UGNX-5 - How to Create Animation
I'm now getting the understanding on how this animation works in NX.