B16.5 Missing Tolerancing
B16.5 Missing Tolerancing
(OP)
Is there an 'industry-standard' accepted tolerance for concentricity between the bolt circle and a slip-on flange I.D.? I cannot find this in B16.5, implied or otherwise. This would be a very useful tolerance for those concerned with fit, and those tolerancing an assembly that uses B16.5 flanges. (Read: Why does it seem this tolerance isn't set by ASME?!)
--------------------------------
Fitter, happier, more productive





RE: B16.5 Missing Tolerancing
RE: B16.5 Missing Tolerancing
Thanks!
--------------------------------
Fitter, happier, more productive