Need opinions on exploded drawing view
Need opinions on exploded drawing view
(OP)
I would like to show a cylindrical assembly in an exploded view. Think of something similar to a tube of lip balm with a label that fully wraps the whole assembly. Would you show it in a wrapped form in line with the cylindrical axis? or as a flattened view above the assembly showing that it intends to act as a final over lay ? Please venture opinions/ experiences on how to illustrate the final label. There are components that are designed into the wall of the cylinder that need to be shown exploded radially away from the wall. Any opinions appreciated.






RE: Need opinions on exploded drawing view
It comes down to your company's processes, how would the drawings work there.
Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion
RE: Need opinions on exploded drawing view
"Art without engineering is dreaming; Engineering without art is calculating."
Have you read FAQ731-376: Eng-Tips.com Forum Policies to make the best use of these Forums?
RE: Need opinions on exploded drawing view
Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog
RE: Need opinions on exploded drawing view