Work Piece Won't Update, Keeps Saying (The input must be a number)
Work Piece Won't Update, Keeps Saying (The input must be a number)
(OP)
I am you using NX 7.5 MR2, and everytime I go to update my work piece I keep getting the (Alerts) that says The inpute must be a number, now I know somebody out there is going to say so input a number did that LOL, tried a lot of things, but it keeps saying that. It will not change the numbers for some reason, anybody else run into this problem, help would be greatly appreciated.
I have attached a picture to show the alert.




