Threads in Inventor
Threads in Inventor
(OP)
In Inventor 2011, in a part file, on the ribbon, under model tab, in the modify panel, I pick "Thread".
No display comes up.
I wanted to add an external thread to a rod.
I just recently updated from 2010 to 2011, and I had the display for the "thread" come up in 2010.
Is there a setting somewhere I could be missing?
Thanks
No display comes up.
I wanted to add an external thread to a rod.
I just recently updated from 2010 to 2011, and I had the display for the "thread" come up in 2010.
Is there a setting somewhere I could be missing?
Thanks





RE: Threads in Inventor
If so, did you follow the Autodesk Clean Uninstall document?
http:/
then run
http:/
when installing 2011 did you turn off anti-virus and UAC during install?
Try a Repair Install?
Install Service Pack 1?