Surface Area of Piping
Surface Area of Piping
(OP)
Is it possible to return only the inside or outside surface area of piping?
It seems I can only get an all or nothing result. And if I try to model just a surface the mass properties are greyed out.
Thanks in advance.
It seems I can only get an all or nothing result. And if I try to model just a surface the mass properties are greyed out.
Thanks in advance.
60% of the time, it works every time.






RE: Surface Area of Piping
Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion