Surface finish symbol
Surface finish symbol
(OP)
John or somebody,
How could I enable the snap points when I use the Surface finish symbol command in drafting environment?
How could I attach the symbol to any edge of the component without leader?
I can't do it in NX7.5 but it works in NX7 and any below versions.
thanks your help
How could I enable the snap points when I use the Surface finish symbol command in drafting environment?
How could I attach the symbol to any edge of the component without leader?
I can't do it in NX7.5 but it works in NX7 and any below versions.
thanks your help





RE: Surface finish symbol
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Surface finish symbol
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Surface finish symbol
It works.