NX 8.0
NX 8.0
(OP)
I've seen mention a few times lately the next version of NX, I'm assuming it will be NX 8.0. Is there a time frame as to when NX 8.0 will be available?
Also, last year it was mentioned in a few threads that the next version of NX (NX 8.0?)will have greatly upgraded/improved capabilities for shipbuilding/naval architecture/marine engineering. Can someone comment on what those upgrades and new capabilities are?
Thanks,
Mike
Also, last year it was mentioned in a few threads that the next version of NX (NX 8.0?)will have greatly upgraded/improved capabilities for shipbuilding/naval architecture/marine engineering. Can someone comment on what those upgrades and new capabilities are?
Thanks,
Mike





RE: NX 8.0
As for the shipbuilding project and what we're focusing on, since that is WAY out of my area of expertise and experience I've haven't spent hardly any time looking at it. However, when we get closer to the release there will be marketing information being made available for the launch which will cover the basic trust of this effort. Now it is possible that there may be some sessions covering this in more detail at the upcoming PLM Connection in May in Las Vegas. Note that the conference is actually going to happen before the official launch of the "NEXT version of NX" so I don't know how much information about some of the new areas will be presented or not, however let me ask and if it turns out that there will be some worthwhile sessions for this area, perhaps it might pay to consider attending the meeting. If I learn fo any specific shipbuilding presentations planned for the conference I'll post that information here.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 8.0
RE: NX 8.0
I don't mean to be a pain in asking this early. But a while ago you mentioned that they were looking at adding Frame Generator/Weldment style features to NX (ala IV/SW). Is there any info on this at all? I would really LOVE for it to be in NX8 as its one feature that really helps us out a lot.
RE: NX 8.0
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 8.0
Certainly, http://www
As i said its probably still just an idea Siemen's end and still not gone any further. But if you don't ask you'll never know. :)
RE: NX 8.0
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.