Any CK99 users in the Flagstaff, AZ Area?
Any CK99 users in the Flagstaff, AZ Area?
(OP)
I reloaded CK99 as suggested and now I'm not sure how to reload my .kbd, & .tbr settings, and fonts. I put these and my .prt & .ptn files on a seperate drive and brought them back and placed them in an empty folder I created in the CADKEY folder. The .prt &.ptn files are there and I can access them, but no .kbd, .tbr, and font files. Anybody close to Flagstaff?





RE: Any CK99 users in the Flagstaff, AZ Area?
RE: Any CK99 users in the Flagstaff, AZ Area?
RE: Any CK99 users in the Flagstaff, AZ Area?
They don't have the ability on this forum to leave private messages so if you want to contact me go to CNCzone and send me a private message and we can talk over the phone. Maybe I can walk you through this. I still have a copy of CK19 on my computer for some reason. It's similar to CK99 in some ways. BTW I'm in the same time zone as you.
http://www.cnczone.com/forums/index.php
RE: Any CK99 users in the Flagstaff, AZ Area?
RE: Any CK99 users in the Flagstaff, AZ Area?
Did you get this resolved?
h