×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

Exercising Redundant/Emergency Pumps

Exercising Redundant/Emergency Pumps

Exercising Redundant/Emergency Pumps

(OP)
I work for a water utility that has many redundant/emergency pumps installed.  Most of these are split case pumps in the 100 to 200 HP range, although we also have several idle lineshaft deep well pumps.  Is there literature that addresses how often  these pumps should be operated to ensure they remain in working condition?   

RE: Exercising Redundant/Emergency Pumps

We have approximately 2000 pumps in our oil refinery.  Of those, about 1500 are centrifugal pumps with an average size of about 100 HP.  For many years, we did not have any requirement for running the spares.  However, back when I started, the average pump in service was failing once every 12 months, so they got run at least that much.  We found, that as our reliability improved, the spare pumps were getting run less and less.  Eventually, we had severe problems when spare pumps would not run because they had been sitting idle for too long.  Our current policy for all centrifugal pumps is that we switch pumps and run them once per month for at least four hours.  For pumps in services where it is risky to switch pumps, we have an absolute requirement that they must be run at least once every three months. While they are running, we take vibration data to assess the health of the bearings, couplings, etc.  I have not seen any literature with standards stating a maximum interval between running spare pumps.   

Johnny Pellin

RE: Exercising Redundant/Emergency Pumps

what does the pump mfgr have to say/recommend?

RE: Exercising Redundant/Emergency Pumps

Don't have designated spares.  Rotate equipment equally through normal service hours.   

Let your acquaintances be many, but your advisors one in a thousand'  ...  Book of Ecclesiasticus

RE: Exercising Redundant/Emergency Pumps

For the bearings, the number I always hear floated is to rotate the shafts every three months but I don't know how much of a safety factor is built into that number.  .  For convenience, I would have it coincide with checking lubrication in bearing frames.   

RE: Exercising Redundant/Emergency Pumps

If by "emergency" you mean firepumps, there are NFPA20 guidelines for how often equipment should be run.  Off the top of my head, I believe pumps need to be operated through a flow loop 30 minutes at a time, every 2 weeks.  Annually, the firepump performance needs to be verified against pump OEM test curves.  Finally, every three years the entire system needs to be tested for proper operation.

RE: Exercising Redundant/Emergency Pumps

Good day all, I work in a Coal fired power facility.  Here is been my experience with redundant system pumps of which we have 386 or so.  For the longest time they were not getting used and a run till failure mentality was the norm.  The discovery was with some units that could be a very long time and when the redundant system was started it would lose a seal or a bearing shortly after start up.  We have since implemented a three month cycle of operation.  This has done two things, it has allowed us a set down time for a system to perform preventative maintenance and trouble shoot suspected bearing failures due to vibration and oil analysis.  

Spud

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources