Simulation on a Multibody part
Simulation on a Multibody part
(OP)
Greetings all,
I have a multibody part that I was looking to run simulation on for bending analysis but SW comes back with a message stating "can only be done on one body and the rest will be ignored." I have SW Professional with the full sim package and I thought this would work. Is there a way to run the simulation on a multibody part or do I need to make it an assembly possibly? The multibody part was created as a weldment.
Thanks for options.
BB
I have a multibody part that I was looking to run simulation on for bending analysis but SW comes back with a message stating "can only be done on one body and the rest will be ignored." I have SW Professional with the full sim package and I thought this would work. Is there a way to run the simulation on a multibody part or do I need to make it an assembly possibly? The multibody part was created as a weldment.
Thanks for options.
BB
www.phoenixdyno.com
Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.






RE: Simulation on a Multibody part
I was under the impression you could bring a weldment into Sim as beam elements. Then bodies don't matter.
TOP
CSWP, BSSE
www.engtran.com www.niswug.org
www.linkedin.com/in/engineeringtransport
"Node news is good news."
RE: Simulation on a Multibody part
-Dustin
Professional Engineer
Pretty good with SolidWorks
RE: Simulation on a Multibody part
TOP
CSWP, BSSE
www.engtran.com www.niswug.org
www.linkedin.com/in/engineeringtransport
"Node news is good news."