Tracking Bar
Tracking Bar
(OP)
This is a NX5 question.
When double clicking on a curve to change parameters (length and angle), a tracking bar poped up.
Where can I re-activate it, mine doesn't come up anymore.
When double clicking on a curve to change parameters (length and angle), a tracking bar poped up.
Where can I re-activate it, mine doesn't come up anymore.





RE: Tracking Bar
If that doesn't take care of it, let us know.
RE: Tracking Bar
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.
RE: Tracking Bar
RE: Tracking Bar
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
http://www.plmworld.org/museum/
To an Engineer, the glass is twice as big as it needs to be.