Solid Edge - Changing View in Drawing
Solid Edge - Changing View in Drawing
(OP)
Hello,
When I create a drawing from an assembly the isometric view (3D drawing) is pointing in the wrong direction so I cannot see a few of the main features. Is it possible to flip the view so that I see it from the other side?
Many Thanks
Dave
When I create a drawing from an assembly the isometric view (3D drawing) is pointing in the wrong direction so I cannot see a few of the main features. Is it possible to flip the view so that I see it from the other side?
Many Thanks
Dave





RE: Solid Edge - Changing View in Drawing
I have figured it out so dont worry:)
Thanks
Dave